Instrument Cluster Finish Panel - Navigator

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

Courtesy of FORD MOTOR COMPANY

Item	Part Number	Description
1	W707628	Steering column opening trim panel screws (3 required)
2	04459	Steering column opening trim panel
3	W707628	Instrument cluster finish panel screw
4	04320	Instrument cluster finish panel

1.

Lower the steering column to the lowest position.

2.

Remove the 3 screws and the lower steering column cover.
- Disconnect the electrical connector for the brake pedal switch (if equipped).

3.

Remove the instrument cluster finish panel screw.

NOTE: Cluster finish panel removed for clarity.

NOTE: There are 2 locking tabs on the outboard register that need to be pressed before the cluster finish panel is removed.

4.
Press the 2 locking tabs release the clips and remove the cluster finish panel.
- Access the tabs from under the instrument panel.
- Disconnect the electrical connectors.

Courtesy of FORD MOTOR COMPANY

5.

To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.