Console - Front, Floor, Expedition: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

1.

Install the front floor console.

2.

Connect the front floor console electrical connectors.
- Tighten the bulkhead electrical connector bolts to 3 Nm (27 lb-in).

3.

Install the front floor console front screws.
- Tighten to 7 Nm (62 lb-in).

Courtesy of FORD MOTOR COMPANY

Vehicles with floor shift

4.

Install the selector lever cable.

5.

Install the selector lever indicator bezel.

All Vehicles

6.

Install the floor console upper finish panel.
- Connect electrical connector(s).
- Make sure to align the trim panel retaining clips to the retaining clip holes in the floor console.

7.

Install the front floor console utility tray screw.

8.

Install the front floor console utility tray mat.

Vehicles with floor shift

9.

Install the selector lever trim ring.

All vehicles

10.

Install the 2 front floor console front bolts.
- Tighten to 7 Nm (62 lb-in).

11.

Install the 2 front floor console front bolt covers.

12.

Position the front seats forward.

13.

Install the 2 front floor console rear bolts.
- Tighten to 7 Nm (62 lb-in).

Courtesy of FORD MOTOR COMPANY

14.

Position the front seats rearward.

Vehicles with floor shift

15.

Position the selector lever in the PARK position.

All vehicles

16.

Release the parking brake.