Window Glass - Front Door: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Install the front window glass but do not tighten the window glass clamp bolts.

2.

Position the front door glass channel and tighten the bolt to 11 Nm (97 lb-in).

Courtesy of FORD MOTOR COMPANY

3.

Install the inside glass weatherstrip.

Courtesy of FORD MOTOR COMPANY

4.

Raise the window glass until it stalls in the UP position. Tighten the window glass clamp bolts to 11 Nm (97 lb-in).

5.

Disconnect the window control switch electrical connectors and reinstall the switch into the door trim panel.

6.

Install the front door weathershield.

Courtesy of FORD MOTOR COMPANY

7.

Install the front door speaker.
- Connect the electrical connector and install the screws.

Courtesy of FORD MOTOR COMPANY

8.

Install the front door trim panel. For additional information, refer to Interior Trim and Ornamentation .
- The power window regulator motor must be initialized whenever the LF/RF (Navigator) or LF (Expedition) motor is removed from the vehicle. For additional information, refer to Window Motor Initialization .