LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Exterior Lighting System) >> Removal And Installation >> Fog Lamp Bulb >> Removal

Fog Lamp Bulb: Removal

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE: The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the fog lamp with the bulb removed from the fog lamp.
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
NOTE: LH side is shown, RH is similar.

  1. 1.

    Disconnect the foglamp electrical connector.
GFD137014Courtesy of FORD MOTOR COMPANY

  1. 2.

    Turn the fog lamp bulb counter clock-wise and remove the bulb.
GFD137019Courtesy of FORD MOTOR COMPANY