Rear Toe Link: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Using the index marks made in removal Step 2, transfer the marks onto the new cam bolt and cam washer.

2.

NOTE: Do not tighten the nut at this time.

Align the index marks and loosely install the new toe link-to-wheel knuckle bolt and washer.

3.

NOTE: Do not tighten the bolt at this time.

Loosely install the new toe link-to-frame cam bolt, cam washer and nut.

4.

Install the wheel and tire. For additional information, refer to Wheels and Tires .

5.

Lower the vehicle so that the weight of the vehicle is resting on the wheel and tires.

6.

Tighten the toe link-to-wheel knuckle bolt to 225 Nm (166 lb-ft).

7.

Align the index marks and tighten the toe link-to-frame cam nut to 275 Nm (203 lb-ft).

8.

Check and, if necessary, adjust the rear toe. For additional information, refer to Suspension System General Information .