Rear Ball Joint - Lower: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: Do not damage the ball joint boot when installing the special tool.

NOTE: Clean and inspect the ball joint bore for bore damage before installing a new ball joint.

Using the C-Frame and Screw Installer/Remover and the Ball Joint Installer/Remover, install the ball joint.

GFD134354

Courtesy of FORD MOTOR COMPANY

2.

NOTE: Always use a new ball joint snap ring.

Install a new snap ring.

3.

Install the wheel knuckle. For additional information, refer to Wheel Knuckle .