Front Wheel Knuckle: Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.NOTE: If necessary.
Position the brake disc shield and install the 3 brake disc shield bolts.
- Tighten to 17 Nm (150 lb-in).
- 2.
Position the wheel knuckle and install the new lower ball joint nut.- Tighten to 175 Nm (129 lb-ft).
- 5.NOTE: If equipped with dynamic suspension.
Position the height sensor arm bracket and install the height sensor arm bracket screw.
- Tighten to 20 Nm (177 lb-in).
- 6.
- 1.
Position the brake hose bracket and install the brake hose bracket bolt.- Tighten to 12 Nm (106 lb-in).
- 2.
Position the IWE vacuum lines.
- 1.
- 7.
Attach the tie rod end to the wheel knuckle and install the new tie rod end nut.- Tighten to 115 Nm (85 lb-ft).
- 8.
Install the wheel bearing and wheel hub. Refer to Wheel Bearing and Wheel Hub .