Front Wheel Studs: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 3 to 4) to allow the wheel stud to fully seat against the hub flange.

Install the wheel stud.
- Tighten the wheel nut until the wheel stud is seated against the hub flange.
- Discard the wheel nut.

Courtesy of FORD MOTOR COMPANY

2.

Install the brake disc. Refer to Front Disc Brake .