Toe Adjustment - Rear

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before carrying out a toe adjustment, check the tires for the correct pressure. Inspect the tires for incorrect wear or damage. Inspect the suspension for wear or damage.

1.

Using alignment equipment and the manufacturer's instructions, measure the rear toe.
- Refer to Alignment Specifications in the Specifications for optimal alignment settings.
- If the rear toe values are not within specification, go to the next step.

2.

Loosen the toe link cam bolt nut(s).

GFD134271

Courtesy of FORD MOTOR COMPANY

3.

Rotate the toe link cam bolt(s) until the toe setting is within specification.

GFD134272

Courtesy of FORD MOTOR COMPANY

4.

NOTE: Make sure the toe settings are not disturbed while tightening the cam nut(s).

Tighten the toe link cam bolt nut(s) to 275 Nm (203 lb-ft).

5.

Recheck the rear toe setting, adjust as necessary.