Toe Adjustment - Front

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Using alignment equipment and the manufacturer's instructions, measure the front toe.
- Refer to Alignment Specifications in the Specifications for optimal alignment settings.
- If the front toe values are not within specification, go to the next step.

2.

Start the engine and center the steering wheel.

3.

Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

4.

Remove the steering gear bellows clamp(s).

Courtesy of FORD MOTOR COMPANY

5.

Loosen the tie-rod end jam nut(s).

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Do not allow the steering gear bellows to twist while rotating the tie rod.

Rotate the tie rod(s) to achieve the desired toe setting.

Courtesy of FORD MOTOR COMPANY

7.

NOTE: Make sure to hold the tie-rod end stationary while tightening the jam nut or damage to the boot may occur.

NOTE: Make sure that the toe settings are not disturbed while tightening the jam nuts.

Tighten the tie-rod end jam nut(s) to 103 Nm (76 lb-ft).

Courtesy of FORD MOTOR COMPANY

8.

Install the steering gear bellows clamp(s).

Courtesy of FORD MOTOR COMPANY