Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the brake pads. For additional information, refer to Brake Pads .

2.

Remove and discard the 2 brake caliper anchor plate bolts.
- To install, tighten the new bolts to 250 Nm (184 lb-ft).

3.

Clean any rust or foreign material from the anchor plate and wheel knuckle.
- Use specified parts cleaner to clean mating surfaces.

4.

To install, reverse the removal procedure.