Window Regulator Motor - Rear Quarter: Removal

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

>Removal

1.

Remove the D-pillar trim panel. For additional information, refer to Interior Trim and Ornamentation .

2.

Disconnect the rear quarter window regulator motor.
- Remove the retaining clip.

GFD137723

Courtesy of FORD MOTOR COMPANY

3.

Remove the bolts and rear quarter window regulator motor.
- To install, tighten to 7 Nm (62 lb-in).
- Disconnect the electrical connector.

GFD137717

Courtesy of FORD MOTOR COMPANY

4.

To install, reverse the removal procedure.