Bumper - Rear: Removal

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the rear bumper cover. Refer to Bumper Cover - Rear .

2.

Remove the bolts and lower the exhaust system.

Courtesy of FORD MOTOR COMPANY

3.

Disconnect the wiring harness.

Courtesy of FORD MOTOR COMPANY

4.

With the help of an assistant, remove the rear bumper.
- 1.
  
  Remove the bolts.
  - To install, tighten to 175 Nm (129 lb-ft).
- 2.
  
  Remove the bolts.
  - To install, tighten to 275 Nm (203 lb-ft).

Courtesy of FORD MOTOR COMPANY