Block Heater: Removal

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Thermostat mounted (if equipped)

1.

Remove the air cleaner outlet pipe. For additional information, refer to Intake Air Distribution and Filtering .

2.

NOTE: To install, route the block heater power cable away from hot or rotating components, or the cable can be damaged.

Disconnect the block heater electrical connector and unclip the vapor tube from the reataining clip.

GFD135176

Courtesy of FORD MOTOR COMPANY

3.

Remove the bolt and the CAC tube bracket.
- To install, tighten to 6 Nm (53 lb-in).

GFD135614

Courtesy of FORD MOTOR COMPANY

4.

Remove the block heater.
- To install, tighten to 6.2 Nm (55 lb-in).

GFD135615

Courtesy of FORD MOTOR COMPANY

Block mounted (if equipped)

5.

Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .

6.

Release the underbody splash shield fasteners and remove the underbody splash shield.

GFD135616

Courtesy of FORD MOTOR COMPANY

7.

If equipped, remove the skid plate bolts and remove the skid plate.
- To install tighten to 40 Nm (30 lb-ft).

GFD135617

Courtesy of FORD MOTOR COMPANY

8.
- 1.
  
  Position the block heater harness heat shield aside.
- 2.
  
  Disconnect the block heater electrical connector.

GFD135618

Courtesy of FORD MOTOR COMPANY

9.

Using the block heater socket remove the block heater.
- To install tighten to 40 Nm (30 lb-ft).

GFD135619

Courtesy of FORD MOTOR COMPANY