Turbocharger Oil Supply Tube - LH: Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Install the new turbocharger oil tube assembly O-ring seal. Lubricate the new turbocharger oil tube assembly O-ring seal with clean engine oil.

Courtesy of FORD MOTOR COMPANY

2.

Inspect the turbocharger oil supply tube-to-engine block fitting and replace as needed. Tighten to 48 Nm (35 lb-ft).

Courtesy of FORD MOTOR COMPANY

3.

NOTE: Lubricate the cylinder block bore with clean engine oil.

Install the turbocharger oil tube assembly and install the turbocharger oil tube assembly lower bolt.
- Tighten the turbocharger oil tube assembly lower bolt in the following 2 stages.
  - Tighten to 8 Nm (71 lb-in).
  - Tighten an additional 30 degrees.

Courtesy of FORD MOTOR COMPANY

4.

Install the Turbocharger - LH, refer to Turbocharger - LH .