LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 505 (Information And Entertainment Systems - SONY Audio System) >> Removal And Installation >> Antenna - Satellite Radio >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies to both the stand-alone satellite radio antenna and the combination satellite radio/Global Positioning System(GPS) antenna.

  1. 1.

    Remove the RH A-pillar trim panel. For additional information, refer to Interior Trim and Ornamentation .

  1. 2.

    Remove the 3 screws and the RH sun visor.
    • Disconnect the electrical connector, if equipped.

  1. 3.

    Disconnect the satellite radio antenna electrical connector.

  1. 4.

    Lower the headliner enough to gain access to the satellite radio antenna bolt.

  1. 5.

    Loosen the bolt and remove the satellite radio antenna.
    • To install, tighten the bolt to 7 Nm (62 lb-in).

  1. 6.

    To install, reverse the removal procedure.