Seat Cushion Heater Mat: Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

If needed, install a new cushion foam pad.

2.

NOTE: Remove all paper strips from the adhesive before applying the heater mat to the foam pad. Otherwise, damage to the seat can occur.

Install the heater mat to the foam pad.
- Align the heater mat square to the seat cushion with the narrow area of the heater mat tucked into the valley of the foam pad and the wiring toward the rear edge of the seat cushion frame.
- Firmly apply the heater mat to the foam pad making sure it is straight and free of any wrinkles that may show through the cushion cover.

3.

Route the heater mat wire harness as noted in removal.

4.

Install the seat cushion cover. For additional information, refer to Seat Cushion Cover - Second Row, 40 Percent .