Seat - Second Row, 40 Percent: Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Position the seat in the vehicle.
- Align the 2 locator pins to the floor holes.
- Press downward and lock the latch feet to the floor.

2.

Install the 2 seat-to-floor front bolts.
- Tighten to 40 Nm (30 lb-ft).

3.

Install the seat-to-floor bolt front cover.

4.

Using an appropriate tool, push the shipping pin fully inward to unlock the seat from the E-Z entry position.

GFD137590

Courtesy of FORD MOTOR COMPANY

5.

Release the seat to the E-Z entry position.

6.

Install the 2 seat-to-floor rear bolts.
- Tighten to 40 Nm (30 lb-ft).

7.

If equipped, connect the electrical connector and separate the wire harness from the seat.

8.

Install the seat-to-floor rear bolt cover.

9.

Check the seat for correct operation.
- With the seat in the upright or the load floor position, both latch feet must lock to the strikers.
- When releasing the seat to the E-Z entry position, the latches must release freely and not bind to the strikers.
- Make sure the safety belts and buckles are accessible to the occupants after installation.