Seat Cushion - Third Row, 40 Percent: Disassembly

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row .

1.

Remove the seat backrest. For additional information, refer to Seat Backrest - Third Row, 40 Percent .

2.

Remove the inboard and outboard slide bracket-to-cushion frame nuts and slide bracket from both sides of the seat cushion.
- To install, tighten to 15 Nm (133 lb-in).

3.

Remove the 2 seat riser-to-cushion frame bolts and riser.
- To install, tighten to 30 Nm (22 lb-ft).

4.

Release the cushion cover J-clips and remove the cushion frame.

5.

NOTE: Use care when separating the cushion cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the cushion foam pad.

Separate the hook-and-loop strips and invert the cushion cover to the row of hog rings.

6.

Remove all hog rings and cushion cover.

7.

To assemble, reverse the disassembly procedure.