Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the 2 rear floor console front bolts.
- Open the rear floor console storage bin.
- Remove the rear floor console cup holder.
- Remove the rear floor console front bolts.
  - To install, tighten to 12 Nm (106 lb-in).

Courtesy of FORD MOTOR COMPANY

2.

Remove the 2 rear floor console rear bolts.
- Open the rear floor console storage compartment door.
- Remove the rear floor console rear bolts.
- Remove the rear floor console.

Courtesy of FORD MOTOR COMPANY

3.

To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the retaining clip holes in the floor console.