Console - Front, Floor: Removal
WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- 1.
Apply the parking brake.
- 2.
Position the selector lever in the NEUTRAL position.
- 3.
Position the front seats forward.
- 4.
Remove the 2 front floor console rear bolts.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Position the front seats rearward.
- 6.
Remove the 2 front floor console front bolts.
- Remove the 2 front floor console bolt covers.
- Remove the 2 front floor console bolts.
Vehicles with floor shift
- 7.
Remove the selector lever trim ring.
 Courtesy of FORD MOTOR COMPANY
|
All Vehicles
- 8.
Remove the front floor console utility tray mat.
- 9.
Remove the front floor console utility tray screw.
 Courtesy of FORD MOTOR COMPANY
|
- 10.
Remove the floor console upper finish panel.
- Disconnect electrical connector(s).
Vehicles with floor shift
- 11.
Position the selector lever indicator bezel aside.
- Release the 4 retainers and position aside.
 Courtesy of FORD MOTOR COMPANY
|
- 12.
Disconnect the selector lever cable from the selector lever and the floor console.
 Courtesy of FORD MOTOR COMPANY
|
All Vehicles
- 13.
Remove the front floor console front screws.
 Courtesy of FORD MOTOR COMPANY
|
- 14.
Disconnect the front floor console electrical connectors.
- 1.
Loosen the bulkhead electrical connector bolts.
- 2.
Disconnect the bulkhead electrical connectors.
- 3.
Disconnect the electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 15.
Remove the front floor console.