Generator Current Sensor: Removal

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Disconnect the battery. Refer to Battery Disconnect .

2.

Remove the air cleaner outlet tube. Refer to Intake Air Distribution and Filtering .

3.

Disconnect the quick connect couplings and disconnect the turbocharger bypass tube. Refer to Fuel System General Information .

GFD135127

Courtesy of FORD MOTOR COMPANY

4.
- 1.
  
  Release the turbocharger inlet tube from the turbocharger inlet tube bracket grommet.
- 2.
  
  Loosen the turbocharger inlet tube clamp and remove the turbocharger inlet tube.
  - To install, tighten to 5 Nm (44 lb-In).

GFD135128

Courtesy of FORD MOTOR COMPANY

5.

Remove the nut and position the positive battery cable terminal aside, disconnect the generator current sensor electrical connector.
- To install, tighten to 9 Nm (80 lb-in).

GFD136901

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Note the orientation and position of the generator current sensor tape tab.

Index-mark the battery cable at the generator current sensor. Remove and discard the tape securing the generator current sensor to the positive battery cable and remove the generator current sensor.