Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the 2 A-pillar assist handle bolt covers.

2.

Remove the 2 A-pillar assist handle bolts.
- To install, tighten to 5 Nm (44 lb-in).

3.

NOTE: Carefully rotate the A-pillar trim panel during this step.

Remove the A-pillar trim panel.
- Pull the A-pillar trim panel outward to release the A-pillar retaining clips.

4.

NOTE: To avoid damage to the A-pillar trim panel, remove any retaining clips from the body and attach them to the A-pillar trim panel before installing.

To install, reverse the removal procedure.