LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 480 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Ignition Lock Cylinder - Non Functional >> Removal

Ignition Lock Cylinder - Non Functional: Removal

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

  1. 1.

    Remove the Passive Anti-Theft System(PATS) transceiver. Refer to Anti-Theft Passive Anti-Theft System (PATS) .

  1. 2.

    Remove the ignition lock cylinder.
    • Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
    • Use a 3/8-inch diameter drill bit to drill down the middle of the ignition lock key slot until the ignition lock cylinder breaks loose.
    • Remove and discard the ignition lock cylinder and drill shavings from the steering column.

  1. 3.

    Remove the bearing retainer.

  1. 4.

    Remove the steering column lock housing bearing and steering column lock gear.
scientia non olet · About LEMON Manuals