LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Vehicle Dynamic Suspension System) >> Diagnosis And Testing >> Vehicle Dynamic Suspension >> Pinpoint Tests >> Pinpoint Test I : U0140:87 >> Pinpoint Test I : U0140:87

Pinpoint Test I : U0140:87

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

  1. I1 CHECK THE COMMUNICATION NETWORK

    • Ignition ON.
    • Using a scan tool, carry out the Network Test.

    Does the BCM pass the Network Test? 

    Yes  GO to  I2.
    No  DIAGNOSE the BCM does not respond to the scan tool, REFER to Diagnosis and Testing in Module Configuration .

  2. I2 CHECK THE VDM CMDTCs

    • Using a diagnostic scan tool, carry out the VDM self-test.
    • Clear the DTCs.
    • Ignition OFF.
    • Ignition ON.
    • Using a diagnostic scan tool, carry out the VDM self-test.
    • Record the VDM DTCs.

    Is DTC U0140:87 retrieved again? 

    Yes  GO to  I3.
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  3. I3 REVIEW THE RECORDED DTCs FROM THE VDM SELF-TEST

    • Review the recorded DTCs from the VDM self-test.

    Is DTC U3003:16 or U3003:17 recorded? 

    Yes  For DTC U3003:16, GO to Pinpoint Test A .For DTC U3003:17, GO to Pinpoint Test B .
    No  GO to  I4.

  4. I4 CHECK FOR DTCs IN THE BCM

    • Using a diagnostic scan tool, carry out the BCM self-test.

    Is DTC U3003:16 or U3003:17 present? 

    Yes  DIAGNOSE the BCM DTCs. REFER to Diagnosis and Testing in Multifunction Electronic Modules .
    No  GO to  I5.

  5. I5 CHECK FOR DTC U0140 OR U0140:XX SET IN OTHER MODULES

    • Using a diagnostic scan tool, carry out the self-test for all modules.
    • Retrieve the CMDTCs from all modules.

    Is DTC U0140 or U0140:xx set in 1 or more modules in addition to the VDM ? 

    Yes  CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSBs address this concern, Refer to BCM Hardware Testing .
    No  CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSBs address this concern, INSTALL a new VDM. REFER to Vehicle Dynamics Module (VDM) .
scientia non olet · About LEMON Manuals