Front Wheel Knuckle: Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: If necessary.

Position the brake disc shield and install the 3 brake disc shield bolts.
- Tighten to 17 Nm (150 lb-in).

Courtesy of FORD MOTOR COMPANY

2.

Position the wheel knuckle and install the new lower ball joint nut.
- Tighten to 175 Nm (129 lb-ft).

Courtesy of FORD MOTOR COMPANY

3.

Install the new upper ball joint nut.
- Tighten to 115 Nm (85 lb-ft).

Courtesy of FORD MOTOR COMPANY

4.

Install the 3 IWE bolts.
- Tighten to 12 Nm (106 lb-in).

Courtesy of FORD MOTOR COMPANY

5.

NOTE: If equipped with dynamic suspension.

Position the height sensor arm bracket and install the height sensor arm bracket screw.
- Tighten to 20 Nm (177 lb-in).

Courtesy of FORD MOTOR COMPANY

6.
- 1.
  
  Position the brake hose bracket and install the brake hose bracket bolt.
  - Tighten to 12 Nm (106 lb-in).
- 2.
  
  Position the IWE vacuum lines.

Courtesy of FORD MOTOR COMPANY

7.

Attach the tie rod end to the wheel knuckle and install the new tie rod end nut.
- Tighten to 115 Nm (85 lb-ft).

Courtesy of FORD MOTOR COMPANY

8.

Install the wheel bearing and wheel hub. Refer to Wheel Bearing and Wheel Hub .

9.

If equipped with dynamic suspension, calibrate the suspension height sensor. Connect the scan tool and carry out the Ride Height Calibration routine. Follow the scan tool directions.