Front Upper Arm: Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: Tighten the suspension bushing fasteners with the suspension loaded or with the weight of the vehicle resting on the wheels and tires, otherwise incorrect clamp load and bushing damage may occur.

NOTE: Finger tight at this stage.

Position the upper arm and install the 2 new upper arm-to-frame bolts and nuts.

Courtesy of FORD MOTOR COMPANY

2.

Install the shock absorber and spring assembly. Refer to Shock Absorber and Spring Assembly .

3.

Use a suitable jack to raise the suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement taken during removal (curb height).

Courtesy of FORD MOTOR COMPANY

4.

Tighten the 2 upper arm-to-frame bolts and nuts.
- Tighten to 165 Nm (122 lb-ft).

Courtesy of FORD MOTOR COMPANY