Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan may cause engine failure.

Remove the A/C compressor belt. Refer to: Accessory Drive .

2.

Remove the crankshaft bolt and washer.
- Discard the bolt.

Courtesy of FORD MOTOR COMPANY

3.

Using a three leg puller, remove the crankshaft pulley.

Courtesy of FORD MOTOR COMPANY

4.

Using the Oil Seal Remover, remove and discard the crankshaft front seal.

Courtesy of FORD MOTOR COMPANY