Symptom Chart: Handles, Locks, Latches and Entry Systems - Electrical
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Condition | Possible Sources | Actions |
|---|---|---|
| All door locks are inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test I |
| A single or more than one door lock is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test J |
| One or more door locks operate only one way | Refer to the Pinpoint Test | GO to Pinpoint Test K |
| All door locks are inoperative from one door lock control switch | Refer to the Pinpoint Test | GO to Pinpoint Test L |
| The door lock indicators are inoperative or always on | Refer to the Pinpoint Test | GO to Pinpoint Test M |
| The liftgate/luggage compartment lid latch release is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test N |
| The liftgate/luggage compartment lid latch does not latch | Wiring, terminals or connectors Liftgate/luggage compartment lid latch |
DISCONNECT the liftgate/luggage compartment lid latch electrical connector and CHECK the operation of the latch using a screwdriver. If the latch fully latches (2 clicks), REFER to the OEM ELECTRICAL WIRING DIAGRAM INTRODUCTION (EXCEPT ELECTRIC) to identify the possible causes of the circuit short. If the latch does not fully latch (2 clicks), INSTALL a new latch. For a liftgate, REFER to: Liftgate Latch . For a luggage compartment lid, REFER to: Luggage Compartment Lid Latch . |
| The doors unlock by swiping the keyless entry keypad 2 times | Unintentional sequential codes programmed | ERASE all personal codes, and program new codes. PROGRAM any unused slots with the factory code. REFER to the Owner's Literature. |
| The doors do not lock or unlock using the keyless entry keypad | Refer to the Pinpoint Test | GO to Pinpoint Test O |
| The keyless entry keypad illumination is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test P |
| The keyless entry keypad illumination is always on | Refer to the Pinpoint Test | GO to Pinpoint Test Q |
| The RKE transmitter is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test R |
| An individual button/feature is inoperative from the RKE transmitter | Refer to the Pinpoint Test | GO to Pinpoint Test S |
| The RKE) transmitter has poor range performance | Refer to the Pinpoint Test | GO to Pinpoint Test T |
| The smart unlock is inoperative | Refer to the Pinpoint Test | DIAGNOSE the key-in-ignition warning chime. REFER to: Instrumentation, Message Center and Warning Chimes . |
| The 2-stage door unlocking does not operate correctly | 2-stage door unlocking is disabled | PROGRAM the 2-stage door unlocking. REFER to: Staged Unlock Programming . |