LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1593 (Roof Opening Panel (Except Electric)) >> General Procedures >> Power Roof Opening Panel Initialization

Power Roof Opening Panel Initialization

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING

Initialization 

  1. WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT ELECTRIC) . Failure to follow this instruction may result in serious personal injury.

    Refer to: Health and Safety Precautions .

    NOTE: Until the initialization procedure is complete, the one-touch open and one-touch close function is disabled.
    NOTE: An initialization procedure that was interrupted or not completed can be started again after cycling the ignition from ON to OFF and back to ON again.
  2. Place the ignition switch in the RUN position. For initializing an existing roof opening panel motor, skip to Step 6.
  3. For a new roof opening panel motor  , press and hold the front portion of the control switch until the roof opening panel glass moves slightly past the full VENT position (approximately 2 mm (0.0787 in)) and stops.
  4. Quickly (within 0.5 second) release, then press and hold the front portion of the control switch while the roof opening panel glass move to the full OPEN position and then back to the full CLOSED position.
  5. Release the switch and verify successful initialization by performing one-touch open and one-touch closed operations.
  6. For an existing roof opening panel motor  , press and hold the front portion of control switch until the roof opening panel glass moves to the full VENT position, then release the switch.
  7. Press and hold the front portion of the control switch for approximately 30 seconds until the roof opening panel glass moves slightly past the full VENT position (approximately 2 mm (0.0787 in)) and stops.
  8. Quickly (within 0.5 second) release, then press and hold the front portion of the control switch while the roof opening panel glass moves to the full OPEN position and then back to the full CLOSED position.
  9. Release the switch and verify successful initialization by performing one-touch open and one-touch closed operations.
scientia non olet · About LEMON Manuals