Pinpoint Test E : The Roof Opening Panel Does Not Open Or Close: Notes

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Roof Opening Panel for schematic and connector information.

Normal Operation and Fault Conditions

The roof opening panel motor/module receives voltage from the accessory delay relay when the ignition is in the ACC or RUN position. The overhead console switch supplies ground signals to the roof opening panel motor/module to operate the roof opening panel. A failure in the power, ground, or control circuits, an internal failure of the switch or motor/module or a motor/module that has not been initialized all cause the roof opening panel to become inoperative.

Possible Sources

Fuse(s)
Wiring, terminals or connectors
Roof opening panel switch
Roof opening panel motor/module assembly
Accessory delay relay
Roof opening panel motor not initialized

Visual Inspection

Roof opening panel
Roof opening panel frame
Roof opening panel drain hoses
Roof opening panel lifter assemblies
Roof opening panel trough
Roof opening panel air deflector assembly
Roof opening panel seal
Roof opening panel shield

Diagnostic Pre-checks

BCM fuse (80) (20A)
RJB fuse (37) (5A)
Circuitry
Accessory delay relay
Roof opening panel switch

If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the pinpoint test.