Front Door Window Regulator: Removal
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front door trim panel. Refer to: FRONT DOOR TRIM PANEL
- Remove the front door speaker.
- Disconnect the front door speaker electrical connector and position aside the wiring harness.
- Remove the retainers and remove the front door speaker.
- Position aside the wiring harness and remove the front door watershield.
- Install the front door window control switch and lower the glass to 2/3 down position.
- Release the retaining clips from front door window glass. Use the General Equipment: Flat Headed Screw Driver
- Tape the front door window glass in place. Use the General Equipment: Adhesive Tape
- Remove the front door window regulator.
- Disconnect the electrical connector and the position aside the wiring harness.
- Remove the nuts and the bolt.