LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1587 (MULTIFUNCTION Electronic Modules (Except Electric)) >> General Procedures >> Transport and Factory Mode Deactivation

Transport and Factory Mode Deactivation

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING

Deactivation 

WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT ELECTRIC) . Failure to follow this instruction may result in serious personal injury.
  1. Refer to: Health and Safety Precautions .
  2. Place the ignition in the OFF position.
  3. Verify the battery is fully charged. Refer to: Battery .
  4. NOTE: On vehicles with Push-Button Start, place a programmed passive key in the PATS backup starting location.

    Place the ignition in the ON position.

  5. NOTE: Steps 5 and 6 must be carried out within 10 seconds.

    Press and release the brake pedal 5 times.

  6. Press and release the hazard switch 2 times (on, off).
  7. NOTE: When exiting Factory mode, the IPC message center will indicate NORMAL MODE when the procedure has been successfully completed.

    Place the ignition in the OFF position.

scientia non olet · About LEMON Manuals