LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (Exterior Lighting (Except Electric)) >> Diagnosis And Testing >> Stoplamps >> Pinpoint Tests >> Pinpoint Test B : One Or More STOPLAMPS Are Inoperative >> Notes

Pinpoint Test B : One Or More STOPLAMPS Are Inoperative: Notes

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Turn Signal/Stop/Hazard Lamps for schematic and connector information.

Normal Operation and Fault Conditions 

REFER to: Exterior Lighting - System Operation and Component Description  .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B1115:11 High Mounted Stop Lamp Control: Circuit Short To Ground A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the high mounted stoplamp voltage supply circuit.
B1115:15 High Mounted Stop Lamp Control: Circuit Short To Battery Or Open A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the high mounted stoplamp voltage supply circuit.
C111A:11 Right Stop Lamp: Circuit Short To Ground A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the right rear stoplamp voltage supply circuit.
C111A:15 Right Stop Lamp: Circuit Short To Battery Or Open A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the right rear stoplamp voltage supply circuit.
C111B:11 Left Stop Lamp: Control: Circuit Short To Ground A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the left rear stoplamp voltage supply circuit.
C111B:15 Left Stop Lamp Control: Circuit Short To Battery Or Open A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the left rear stoplamp voltage supply circuit.
U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information This DTC sets when the BCM has temporarily shut down the output driver. The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description .
U3000:49 Control Module: Internal Electronic Failure This DTC sets when the BCM has permanently shut down the output driver. The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. CORRECT the cause of the excessive current draw before installing a new BCM. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description .

Possible Sources 

scientia non olet · About LEMON Manuals