DTC Chart: FCIM
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description | Action |
|---|---|---|
| U0009:88 | High Speed CAN Communication Bus (-) shorted to Bus (+): Bus off |
NOTE:
The module was unable to communicate on the network at a point in time. The fault is not currently present since the module had to communicate with the diagnostic scan tool to report this DTC. To avoid repeat network concerns: INSPECT for damaged or corroded wiring at the FCIM. Refer to Module Communications Network
for schematic and connector information.CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs).WAIT at least 10 seconds.REPEAT the network test with the diagnostic scan tool. |
| U0155:00 | Lost Communication With IPC Control Module: No Sub Type Information | GO to Pinpoint Test AJ |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. REFER to: Instrumentation, Message Center and Warning Chimes . * If no Diagnostic Trouble Codes (DTCs) are present in the IPC, DIAGNOSE the observable symptom. |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC B10B8:63 is retrieved again, A guided routine is not applicable for this vehicle and market. Replace the component that was faulted through service information diagnosis. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:41 is retrieved again, A guided routine is not applicable for this vehicle and market. Replace the component that was faulted through service information diagnosis. |
| U3000:42 | Control Module: General Memory Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:42 is retrieved again, A guided routine is not applicable for this vehicle and market. Replace the component that was faulted through service information diagnosis. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AP |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AQ |