Pinpoint Test B : Poor Image Quality: Notes

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Audio System/Navigation for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Parking Aid - System Operation and Component Description .

Possible Sources

Dirty or scratched camera lens
Wiring, terminals or connectors
Rear parking aid camera
FCDIM
APIM
Interference from other sources

Visual Inspection and Diagnostic Pre-Checks

Make sure the rear parking aid camera lens is clear of any debris.
If the vehicle is equipped with an 8 in (203 mm) touchscreen display, PERFORM an APIM reset and reevaluate the concern prior to following this pinpoint test. REFER to: SYNC Module [APIM] Programming .

NOTE: Before disconnecting the camera, verify the connector is properly seated and latched.