Network Message Chart
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Module Network Input Messages - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| AWD lock status | AWD module | Input used to display the information indicator along with text messages associated with the AWD system. |
| Air ambient temperature filtered actual | PCM | Input used to provide the outside air temperature display. |
| BLIS system status | SODL | Input used to display the BLIS status and fault messages. |
| Brake fluid level low | BCM | Input used to display the low brake fluid level warning message. |
| Brake warning request | BCM | Input used to display the brake system malfunction warning message. |
| Bulb failure indication | BCM | Input used to display a bulb failure message. |
| Compass direction (touchscreen audio) | APIM | Input used to provide the compass display. |
| Cruise control status | PCM | Input used to control the cruise control RTT indicator. |
| Damper mode status | GFM2 | Input used to display the message center sport mode RTT (RS only). |
| Door status | BCM | Input used to display the individual door ajar warning messages. |
| Drive mode activation | GFM2 | Input used to what damper mode the driver has selected to display the appropriate message center RTT (RS only). |
| Econometer | PCM | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |
| EPAS display | PSCM | Input used to display the service power steering message. |
| Engine coolant temperature | PCM | Input used to display the engine over-temperature message. |
| Engine MIL request | PCM | Input used to display the engine malfunction message. |
| Engine service indication | PCM | Input used to provide the change oil service message display. |
| GPS data (without touchscreen audio) | GPSM | Input used to provide the compass display. |
| Ignition status | BCM | Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting. |
| Key warning indication | BCM | Used to display the key not inside vehicle message (keyless entry only). |
| Lane keeping system hands off display | IPMA | Used to display the hands off steering wheel warning message. |
| Launch control system status | BCM | Input used to display the message launch control RTT (RS only). |
| Parking aid active | PAM | Input used to display the parking aid malfunction and service required messages. |
| Parking aid disable status | PAM | Input used to display the parking aid cannot be disabled message for MyKey®. |
| Parking brake warning request | BCM | Input used to display the parking brake applied message. |
| Passive entry/start indication | BCM | Input used to display the press brake to start message (push button start only). |
| PATS indication | BCM | Input used to display the immobilizer active message for the PATS. |
| Passive key status | RFA module | Used to display the passive key left inside vehicle message and the key not in vehicle message (keyless entry only). |
| Power system status | BCM | Input used to display the charging system warning messages. |
| Primary fuel level | BCM | Fuel level input for the fuel pump assembly on base and ST models and for the (primary or active) side of the fuel tank on RS models. Input is used for fuel economy, DTE and low fuel message displays. |
| Secondary fuel level (RS only) | BCM | Fuel level input for the fuel level sensor (secondary or passive) side of the fuel tank for fuel economy, DTE and low fuel message displays. |
| Stop/start indicator request | PCM | Input used to control auto stop-start RTT indicator. |
| Tire pressure indication | BCM | Input used to display the TPMS malfunction warning messages and the TPMS tire sensor training messages. |
| Transport mode | BCM | Input used to provide the vehicle in transport mode display. |
| Transmission gear display actual | TCM | Input used to display the turn ignition off message (keyless entry only). |
| Transmission message request | RFA | Input used to display transmission related messages and the transmission not in park message. |
| Transmission service required | TCM | Input used to display the transmission malfunction messages. |
| Transmission upshift indication request | PCM | Input used to control the upshift RTT indicator. |
| Washer fluid level low | BCM | Input used to display the low washer fluid message. |
| Wheel rotation count front | ABS module | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |