Pinpoint Test K : DTCS U2008:16, U2008:17 Or U2008:64: Notes
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Refer to OEM WIRING DIAGRAMS (EXCEPT ELECTRIC) for schematic and connector information.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U2008:16 | Sensor Cluster: Circuit Voltage Below Threshold | This CMDTC sets when the AWD control module senses lower than expected voltage on the rear drive unit (RDU) hydraulic pump motor hall effect sensor circuit. |
| U2008:17 | Sensor Cluster: Circuit Voltage Above Threshold | This CMDTC sets when the AWD control module senses greater than expected voltage on the rear drive unit (RDU) hydraulic pump motor hall effect sensor circuit. |
| U2008:64 | Sensor Cluster: Signal Plausibility Failure | This CMDTC sets when the AWD control module detects a short to ground from the RDU hydraulic pump motor hall effect sensor input circuit. |
Possible Sources
- Wiring, terminals or connectors
- AWD control module
- Rear drive unit (RDU)
- Hydraulic pump motor hall effect sensor