Transmission Support Insulator - 2.3L EcoBoost (257kW/350PS) - MI4: Installation

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Install the transmission mounting insulator and inspect the clearance gap. Use the General Equipment: Trolley Jack

Courtesy of FORD MOTOR COMPANY
NOTE: Make sure that a new bolt is installed.

Install the transmission support insulator and the bolt.

Torque

: 109 lb.ft (148 Nm)

Courtesy of FORD MOTOR COMPANY
Install the battery tray bracket.
- Install the battery tray bracket and tighten the nuts.
  Torque
  
  : 35 lb.ft (48 Nm)
Courtesy of FORD MOTOR COMPANY
Attach the retainers and position aside the wiring harness.

Courtesy of FORD MOTOR COMPANY
Install the battery tray. Refer to: Battery Tray .
Remove the General Equipment: Transmission Jack. Remove the General Equipment: Wooden Block
Install the underbody shield.

Courtesy of FORD MOTOR COMPANY