Roll Restrictor RH: Installation

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Install the roll restrictor.
1. Install the roll restrictor and the studbolt.
  Torque
  
  : 59 lb.ft (80 Nm)
2. Install the studbolt, the bolt and tighten.
  Torque
  
  : 59 lb.ft (80 Nm)
Courtesy of FORD MOTOR COMPANY
1. Install the inspection cover. Install the catalytic converter support bracket and the nuts.
  Torque
  
  : 18 lb.ft (25 Nm)
Courtesy of FORD MOTOR COMPANY
NOTE: Bracket not shown.

Install the bolts.

Torque

: 92 lb.ft (125 Nm)

Courtesy of FORD MOTOR COMPANY
1. Install the underbody shield.
2. Install the air deflector.

Courtesy of FORD MOTOR COMPANY