LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1542 (Manual Transmission - 6-Speed Manual Transmission - B6) >> Disassembly And Assembly Of Subassemblies >> Reverse Gear Output Shaft >> Assembly

Reverse Gear Output Shaft: Assembly

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the reverse gear friction rings.

    Material

    : Motorcraft® Dual Clutch Transmission Fluid / XT-11-QDC (WSS-M2C200-D2)

    GFD268864Courtesy of FORD MOTOR COMPANY
  2. Install the reverse gear synchronizer ring and the synchronizer body. Make sure the tab on the upper friction ring aligns with the opening in the synchronizer body and the tabs on the lower friction ring fit into the reverse gear. Use Special Service Tool: 308-416 Remover/Installer, Thrust Washer Bearing Cup.
    GFD268865Courtesy of FORD MOTOR COMPANY
  3. Install the bearing. Use Special Service Tool: 307-679 Installer, Countershaft Needle Bearing. Use the General Equipment: Hydraulic Press
    GFD268866Courtesy of FORD MOTOR COMPANY
  4. Install the bearing. Use Special Service Tool: 307-679 Installer, Countershaft Needle Bearing., 205-D016 (D80L-630-5) Step Plate. Use the General Equipment: Hydraulic Press
GFD268867Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals