Cylinder Head Temperature (CHT) Sensor: Removal

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When removing any turbocharger air intake system components, make sure to cover any open ports to prevent debris from entering the system. The turbocharger compressor vanes can be damaged by even the smallest particles. All components need to be inspected and cleaned prior to installation or reassembly.

NOTE: Removal steps in this procedure may contain installation details.

Remove the engine appearance cover.

Courtesy of FORD MOTOR COMPANY
Disconnect the vent tube and remove the air cleaner outlet pipe.
Torque

:Bolt: 89 lb.in (10 Nm) Clamp: 44 lb.in (5 Nm)

Courtesy of FORD MOTOR COMPANY
Disconnect the electrical connector and remove the crankcase vent tube.

Courtesy of FORD MOTOR COMPANY
Position aside the shield and disconnect the CHT sensor.

Courtesy of FORD MOTOR COMPANY
NOTE: Make sure that a new component is installed.

Remove the CHT sensor.

Torque

: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY