Fuel Rail Pressure (FRP) Sensor: Installation

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Install the FRP sensor and tighten in 5 stages:
- Stage 1:
  Torque
  
  : 53 lb.in (6 Nm)
- Stage 2:
  Angle
  
  : 5°
- Stage 3: Loosen:: 90°
- Stage 4:
  Torque
  
  : 53 lb.in (6 Nm)
- Stage 5:
  Angle
  
  : 21°
Courtesy of FORD MOTOR COMPANY
Install the FRP sensor electrical connector.

Courtesy of FORD MOTOR COMPANY
Connect the battery ground cable. Refer to: Battery Disconnect and Connect .