LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1521 (Engine Ignition - 1.0L ECOBOOST (92KW/125PS)) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal

Ignition Coil-On-Plug: Removal

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil filler cap and then remove the engine appearance cover. Install the oil filler cap.
    GFD264596Courtesy of FORD MOTOR COMPANY
  2. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
    NOTE: If equipped with a sliding cover over the locking tab, then slide the cover back to gain access to the tab.

    1. Slide the red locking tab (CPA) back away from the ignition coil-on-plug, depress the latch and then remove the connector from the ignition coil-on-plug.
    2. Remove the ignition coil-on-plug bolts.
    3. Using compressed air, remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs. Remove the ignition coil-on-plugs.

GFD267221Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals