Pinpoint Test A : Engine Does Not Crank: Notes
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Starting System for schematic and connector information.
Refer to Turn Signal/Stop/Hazard Lamps for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | The PCM sets this DTC when no engine rotation is detected during a crank event. |
| P0833:23 | Clutch Pedal Switch B Circuit: Signal Stuck Low | This DTC sets when the BCM detects a short to ground on the clutch bottom of travel circuit during an on-demand self test. |
Possible Sources
- Battery
- Battery cables
- Starter motor
- BJB starter relay
- CPP switch
Visual Inspection and Diagnostic Pre-checks
- Inspect high current BJB connections.
- Inspect BJB fuse 13 (30A).
- Inspect BCM fuse 78 (5A).
- Inspect the Integrated Keyhead Transmitter (IKT).