Symptom Chart(s)
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart: Starting System
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods for information about these practices.
Symptom Chart
| Condition | Possible Sources | Actions |
|---|---|---|
| The engine does not crank (without push button start) | Refer to the Pinpoint Test. | GO to Pinpoint Test A |
| The engine does not crank (with push button start) | Refer to the Pinpoint Test. | GO to Pinpoint Test B |
| The engine cranks slowly | Refer to the Pinpoint Test. | CARRY OUT the starter system component test. Refer to Starter Motor - Positive Circuit Test . |
| The engine cranks but will not start | Fuses PCM Fuel Pump Fuel Pump Relay Wiring, terminals or connectors |
Refer to ENGINE CONTROLS - SYMPTOM CHARTS (EXCEPT DIESEL & HYBRID) . |
| Unusual starter noise | Refer to the Pinpoint Test. | GO to Pinpoint Test C |
| The starter spins but the engine does not crank | Starter motor | INSPECT the starter motor mounting and engagement. REPAIR as necessary. |
| Damaged flexplate | INSPECT the flexplate for damaged, missing or worn teeth. REPAIR as necessary. | |
| The starter does not disengage from the flexplate | Starter relay Wiring, terminals or connectors |
REMOVE the starter relay. If the engine stops cranking, INSTALL a new relay. If the engine continues to crank, REPAIR circuit CDC35 (BU/WH) for a short to voltage. |
| The remote start is inoperative | Refer to the Pinpoint Test. | GO to Pinpoint Test H |