Pinpoint Test A : Engine Does Not Crank (Without Push Button Start): Notes
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Starting System for schematic and connector information.
Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | The PCM sets this DTC when no engine rotation is detected during a crank event. |
| P0850 | Park/Neutral Switch Input Circuit | This DTC sets when the PCM detects a mismatch between the hardwired park/neutral circuit and the message broadcast over the High Speed Controller Area Network (HS-CAN). |
| P0833:23 | Clutch Pedal Switch B Circuit: Signal Stuck Low | This DTC sets when the BCM detects a short to ground on the clutch bottom of travel circuit during an on-demand self test. |
Possible Sources
- Battery
- Battery cables
- BJB starter relay
- CPP switch (manual transmission only)
- Starter motor
Visual Inspection and Diagnostic Pre-checks
- Inspect the high current BJB connections.
- Verify the BJB fuse 13 (30A).
- Verify the BCM fuse 78 (5A).
- Inspect the Integrated Keyhead Transmitter (IKT).