Pinpoint Test A : Engine Does Not Crank: Notes
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Starting System for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - Overview .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | The PCM sets this DTC when no engine rotation is detected during a crank event. |
| P0830 | Clutch Pedal "A" Circuit | The PCM sets this DTC when the PCM receives vehicle speed input, indicating vehicle movement and does not detect the switching input from the clutch pedal position switch. |
| P0833:23 | Clutch Pedal Switch B Circuit: Signal Stuck Low | This DTC sets when the BCM detects a short to ground on the clutch bottom of travel circuit during an on-demand self test. |
Possible Sources
- Battery
- Battery cables
- Starter motor
- BJB starter relay
Visual Inspection and Diagnostic Pre-checks
- Inspect the high current BJB connections.
- Verify the BJB fuse 13 (30A).
- Verify the BCM fuse 78 (5A).
- Inspect the Integrated Keyhead Transmitter (IKT).
- Inspect the CPP switch.