Intake Manifold: Removal
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Disconnect the battery ground. Refer to: Battery Disconnect and Connect .
- Remove the retainers and the underbody shield.
- Detach the wiring harness retainers and position the wiring harness aside.
- Remove the intake manifold mounting bolt.
- Detach the wiring harness retainer and position the wiring harness aside.
- Remove the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .
- Disconnect the throttle body electrical connector and detach the wire harness retainers.
- Disconnect the fuel evaporative tube quick release coupling. Refer to: Quick Release Coupling
.
- Disconnect the vacuum tube quick release coupling at the rear of the intake manifold.
-
NOTE: Position back the intake manifold to allow access to disconnect the crankcase ventilation oil separator tube from the intake manifold.
- Remove the bolts and the intake manifold.
- Disconnect the crankcase vent oil separator tube.