Rear Brake Flexible Hose: Removal

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT ELECTRIC) . Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions .
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
1. Disconnect the brake tube fitting and detach the brake hose.
  Torque
  
  : 133 lb.in (15 Nm)
2. Remove the bolt and position aside the brake flexible hose.
  Torque
  
  : 106 lb.in (12 Nm)
Courtesy of FORD MOTOR COMPANY
Disconnect the fitting and remove the brake hose.
Torque

: 17 lb.ft (23 Nm)

Courtesy of FORD MOTOR COMPANY